Fred B. has spent the past few months reproducing the six missing berth partitions and lower berth seat backs for the DSS&A DULUTH Sleeping car. The berth partitions are an integral component for the berths as they support the upper berths while also separating each berth in the car. The yellow pine pieces are all custom made per the original partitions in the car and they are recessed into the wall framing, the carlines, and the floor.

In late April Fred began installing the beth partitions in the car as seen in the photos below.

By the end of April, all six berth partitions were secured in place. The seat backs were also placed temporarily. The final installation of the seat backs will occur after additional work is completed inside the car including the reconstruction of the new berth seat ends.

Berth partitions and seatbacks installed in the DSS&A DULUTH sleeping car. April 29, 2019.

Next up… on the weekend of May 18-19 volunteers will once again be working on the air brake piping under the DULUTH. Plans call for completing the trainline, signal line and retainer piping during this work session.